Thursday, November 19, 2026
Ford Insider

Ford news, rumors, recalls, sales and deals

E-Series / News

Ford Patched the Godzilla V8’s Idle, and Now a Petition Wants a Recall

Federal safety regulators are weighing whether to open a full investigation into worn camshafts and lifters in Ford's 7.3-liter gasoline V8, the engine Ford calls Godzilla.

A Ford 7.3-liter Godzilla V8 wired up for testing on a dynamometer at Ford's Dearborn lab
A 7.3-liter Godzilla V8 under test at Ford's Dearborn Dynamometer Lab. Photo: Ford

Federal safety regulators are weighing whether to open a full investigation into worn camshafts and lifters in Ford’s 7.3-liter gasoline V8, the engine Ford calls Godzilla.

The review covers an estimated 54,787 vehicles: 2021 and 2022 E-350 cutaways and 2021 F-59 stripped chassis and F-750 medium-duty trucks. The owner who asked for it argues that a failed engine can leave one of these vehicles without power at highway speed with little warning, and that Ford fixed the cause quietly with software instead of calling a recall.

The National Highway Traffic Safety Administration’s Office of Defects Investigation opened defect petition DP26011 on October 23, 2026, after receiving the petition on June 13. The agency’s summary says the petitioner blames oil pressure of roughly 6 psi at a low idle, claiming the thin lubrication chews up the lifter rollers and camshaft lobes until the engine fails, and that Ford knew the root cause and released a calibration that raised idle speed to roughly 1,000 rpm without recalling the vehicles or notifying their owners. The agency counts one incident report and no crashes, fires, injuries or deaths so far. A defect petition is the step before a formal investigation: the office will now grant or deny the request, and opening it is not a finding that a defect exists. Pickup Truck + SUV Talk reported on the petition on November 19.

A white 2021 Ford E-350 cutaway with a utility body parked outside a Ford dealership
A 2021 Ford E-350 cutaway with a Knapheide service body. Photo: Mr.choppers, CC BY-SA 3.0, via Wikimedia Commons

What Ford Has Already Told Dealers

Ford’s own paperwork describes the same failure in plain terms. Customer Satisfaction Program 24B27, whose fourth supplement went to dealers on November 12, 2024, says the variable displacement oil pump in affected trucks delivers oil at low pressure during idle, and that routine long periods of idling can wear the camshaft lobes and valve tappets. Over time, Ford wrote, the engine can begin to misfire and run rough, tap audibly and light the check engine lamp. The fix was a powertrain control module software update for certain 2020-2024 Super Duty pickups and 2021-2025 Econoline ambulance and shuttle bus packages with the 6.8-liter or 7.3-liter gas engine, built at Kentucky Truck and Ohio Assembly. Ford put the US population at 36,323 vehicles, ran the program through November 30, 2025 with no mileage limit, and told dealers to update new trucks still on their lots before delivery.

For engines already worn, Technical Service Bulletin 25-2572, issued on November 25, 2025 to replace an earlier bulletin, tells technicians how to chase an upper-engine ticking at idle, misfire codes P0301 through P0308 and rough running on 2021-2025 E-Series, F-650 and F-750 trucks, 2020-2025 Super Duty pickups and chassis cabs with the 7.3, and 6.8-liter F-53 and F-59 chassis from 2023 to 2025. The procedure starts with the oil filter. If it passes, the cylinder heads come off so the cam, tappets and cylinder walls can be inspected, which can end in a new camshaft and a full set of tappets; if the filter fails, the answer is a new long block. Either repair is paid for under the truck’s normal warranty coverage, which a service bulletin does not extend.

Ford’s heavy-duty diesel is fighting its own battle in court. Pickup Truck + SUV Talk reports that a federal judge in Michigan recently certified classes in five states in Droesser v. Ford Motor Company, a suit claiming the Bosch CP4 high-pressure fuel pump on Power Stroke diesels was not designed for American low-sulfur diesel. Ford’s position, as the outlet describes it, is that pump damage comes from skipped maintenance and harmful fuel additives. No trial date has been set.

What It Means for Super Duty Owners

The petition names only the E-350, F-59 and F-750, but the 7.3 is also the gas engine in the F-250 and F-350, and Ford’s own software program and service bulletin both list Super Duty pickups. An owner of a 2020-2024 Super Duty with the 7.3 can ask a dealer whether program 24B27 was performed on the truck. Ford has not issued a safety recall for the oil-pressure issue.

The Ford Insider Take

Ford’s documents already concede the mechanism the petitioner describes, so the real question for regulators is whether a cam that wears out slowly in a work truck is a safety defect or a durability problem. For an ambulance or a shuttle bus that loses power on the highway, that line is thin, and the fleets that idle these trucks for hours a day are exactly the buyers who would feel it first.

A software update that ran on a deadline also leaves gaps. Any truck that missed the 24B27 visit before November 30, 2025, or that was already worn when it got the update, is left to the warranty and to TSB 25-2572. If NHTSA grants the petition, the next step is a formal investigation that can end in a recall with no deadline at all, and Super Duty owners should watch that decision closely.

ShareXFacebookRedditEmail

Send a tip