Wednesday, November 18, 2026
Ford Insider

Ford news, rumors, recalls, sales and deals

Bronco / Recalls

2026 Ford Bronco Recalled Over Wipers That Can Detach

Ford is recalling 330 2026 Ford Bronco SUVs because a loose nut on the driver-side wiper arm can let the arm slip on its shaft or come off entirely.

2026 Ford Bronco Stroppe Edition four-door kicking up dust on a dry lakebed
Photo: Ford

Ford is recalling 330 2026 Ford Bronco SUVs because a loose nut on the driver-side wiper arm can let the arm slip on its shaft or come off entirely.

The problem traces to two days of production. On September 22, 2026, Michigan Assembly Plant found a low torque reading on the nut securing a Bronco’s driver-side wiper arm during an audit, and Ford later found that a mechanical failure in the fastening tool had applied inaccurate torque. Because the plant records torque data for each vehicle, Ford was able to narrow the recall to Broncos built on September 21 and 22. Its review group concluded that the wipers worked when the vehicles left the line, but that the loose nut could affect them over time or under extra load such as snow. Ford says that as of October 12 it knew of no warranty claims, field reports or owner complaints, and it is not aware of any crashes or injuries. Dealers may not deliver any affected new Bronco still on the lot until it has been repaired.

The defect: the driver-side windshield wiper arm nut may be insufficiently tightened, which could let the wiper arm slip on the pivot shaft or detach.

Line drawing of the base of a Bronco's driver-side windshield wiper arm, with an arrow pointing to the nut on its pivot
The nut on the driver-side wiper arm’s pivot, as drawn in Ford’s repair instructions to dealers. Illustration: Ford, via NHTSA

The hazards: a partial or complete loss of driver-side wiper function can reduce visibility when the wipers are needed, increasing the risk of a crash. Ford says there is no warning before it happens.

Components: driver-side windshield wiper arm assembly (part number M2DB-17527-AA), made by Ford

Affected vehicles: 2026 Ford Bronco built at Michigan Assembly Plant from September 21 to September 22, 2026

Number of vehicles affected: 330

The fix: dealers will check that the driver-side wiper makes a full sweep and tighten the wiper arm nut to specification, and will replace the wiper arm if it fails that check. Repairs will be performed free of charge.

Source: Ford Motor Company’s filing with NHTSA

Owners should: watch for a letter from Ford, which is being mailed between November 16 and November 20, 2026, or contact a Ford dealer now. Affected VINs have been searchable since November 6. Ford’s number for this recall is 26S82.

Contacts:

  • Ford customer service: 1-866-436-7332
  • Ford recall number: 26S82
  • NHTSA campaign number: 26V725000
  • NHTSA vehicle safety hotline: 1-888-327-4236
  • Check a VIN: nhtsa.gov/recalls

ShareXFacebookRedditEmail

Send a tip